Installing The Lp Pressure Regulator - Mendota DXV-45 DT4 Installation & Operating Instructions Manual

INSTALLING THE LP PRESSURE REGULATOR

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically ap-
proved with this appliance may result in property damage or personal injury." AVERTISSEMENT. Risque de dommages
ou de blessures si les pièces ne sont pas installées conformément à ces schémas et ou si des pièces autres que celles
spécifiquement approuvées avec cet appareil sont utilisées.
1. Remove the Courtesy Access Panel mounted behind the lower grill and lay down gently without disconnecting any
wires of internal components. WARNING: DO NOT FORCE. EXCESSIVE FORCE MAY DAMAGE INTERNAL
WIRING COMPONENTS!
2. Pull out and remove Extension Knob on NG Pressure Regulator and set aside.
3. Follow Instructions given below directly from SIT Controls. Replace Extension Knob as the final step.
47