Mendota DXV-45 DT4 Installation & Operating Instructions Manual page 31

9. Identify Log "C". Back left log.
10. Locate holes on bottom of log.
11. Place log "C" onto the 2 pins on left-side
behind the rear burner as shown.
D
LOG "D"
14. The curvature on the bottom left side
sits on top of the rear burner's inlet
tube.
15. Log "D" will be tipped slightly forward
to a maximum of a 10 degree angle
once logs "G" & "H" are installed.
30
LOG "C"
Holes in bottom
of Log "C".
12. Identify Log "D". This log will be installed between the front
and back of the rear burner tube as shown below.
13. Note that on the left end of log "D" is a curvature
bottom edge].
C
Push log "D" up against
inside curve of burner.
along the
[