Resetting To Factory Defaults; External Power Supply - Schlage AD-250 User Manual

Offline lock

Hide thumbs Also See for AD-250:

Table of Contents

AD-250 Offline Lock User Guide

RESETTING TO FACTORY DEFAULTS

All information in the lock will be deleted and reset to factory defaults!

1. Remove the top inside cover.

2. Press and hold Schlage button until two (2) beeps sound (10 seconds).

3. Release the Schlage button.

4. Press and release the inside push button (IPB) three (3) times within 10 seconds. One beep will

sound and one red blink will occur with each press.

5. The Schlage button and IPB will both light green for one second and a one-second beep will be

heard. This indicates that the lock has been reset.

ÎIf IPB is not pressed 3 times within 10 seconds, two beeps with two red blinks indicate timeout

6. Replace the top inside cover.

ÎThe Magnetic Reader will revert to Track 2 after default reset. See the Schlage Utility Software User

Guide for information on how to change track.

The AD-250 may be connected to external power using a UL294 Listed Power Supply capable of

sourcing at least 250 mA @ 12 to 24 VDC.

ÎWhen powered with external power supply, the lock will always fail "As-Is" if power is lost.

–

Polarity Required

Table of Contents