Safety Checks - Wacker Neuson BH 24 Operator's Manual

2.2.15 The tank lid must fit tightly. Shut fuel cock if available when stopping
2.2.16 Stop engine before filling fuel tank. When refilling fuel tank, do not
2.2.17 Make sure that sufficient fresh air is available when operating drilling
2.2.18 Do not operate this machine in areas where explosions may occur.
2.3

Safety checks

2.3.1
2.3.2
2.3.3
2.3.4
2.3.5
SV00044GB.fm
the engine. For long distance transports of machines operated by fuel
of fuel-mixtures, the fuel tank has to be drained competely.
Leaky fuel tanks may cause explosions and must therefore be
replaced immediately.
allow fuel to come into contact with the hot parts of the engine or spill
onto the ground.
and breaking hammers with combustion engines in enclosed areas,
tunnels, adits, or deep trenches. For this particular use we offer
electrically driven drilling and breaking hammers.
Drilling and breaking hammers may only be operated with all safety
devices installed.
Before starting operation, the operator has to check that all control and
safety devices function properly.
Before starting operation, the overload clutch of drilling hammers has
to be checked for proper functioning.
In case of defects of the safety devices or other defects reducing the
operational safety of the drilling and breaking hammers, the supervisor
has to be informed immediately.
The machine must to be switched off immediately in case of defects
jeopardizing the operational safety of the equipment.
15
Safety instructions