Table of Contents
Advertisement
For easier installati on, att ach all tubing prior to mounti ng the
faucet.
1. Insert polished faucet base onto base of faucet.
2. Push the 1/4" drain tubing onto the 1/4" barb fi tti ng. This tube
must be of suffi cient length to reach the white swivel with yellow
collet on the membrane desalinator.
3. Push the 3/8" tubing onto the larger 3/8" barbed fi tti ng, being
sure you have enough tubing to reach the drain saddle.
4. Slip the 1/4" and 3/8" tubing though opening in polished faucet
base. Slide white plasti c spacer open-end-up onto the threaded
faucet stem (2).
5. Thread the 3/8" washer (3) and mounti ng lock nut (4) onto the
threaded stem. (Fig 6)
6. Thread faucet quick-connect adapter (5) on to threads of faucet
stem. NOTE: This connecti on should be hand-ti ghtened only. Push
one end of product tubing into connecti on.
7. Insert tubing and faucet assembly down through the sink hole.
8. Positi on the faucet to the desired handle orientati on. Slip the
slott ed washer (1) between the white plasti c spacer and the sink.
Securely hand ti ghten the mounti ng nut.
9. Connect the 3/8" tubing to the drain saddle assembly using the
drain connector nut supplied. This tubing should follow as direct a
path as possible; long runs, looping or deep sags will restrict nor-
mal brine fl ow to the drain. Save the unused porti on of the tubing
for the installati on of the storage tank.
10. Apply a small amount of silicone-based lubricant to the O-rings
located at the base of the spout. Firmly insert spout assembly into
the top hole of faucet body (approximately 1/4"). You may swivel
the faucet left or right.
CS-2 Push Handle Faucet
41840-A McAlby Court, Murrieta, CA 92562
(800) 451-9343, www.nimbuswater.com
Airgap to system drain
(1/4" tubing)
Metal base plate
Rubber seal
1
2
3
4
5
Faucet to drain
saddle (3/8" tubing)
Product water
(1/4" tubing)
Connect to product
water tubing
6
Advertisement
Table of Contents
