Installation And Setup; Direct Or Shared Network Connection; Direct Network Connection - Mitel 6863i Installation Manual

INSTALLATION AND SETUP

The 6863i SIP Phone can be setup to share a network connection with another network device.
Power can be provided by the power adapter (sold separately), by an 802.3af compliant network
power source, or with a PoE inline power injector.
Notes:
1. This product is designed for indoor use only and for ambient temperatures at
2. The phone must be connected only to indoor routed PoE or Ethernet wiring.

DIRECT OR SHARED NETWORK CONNECTION

The phone can be set up as a direct network connection to the Ethernet wall jack or as a shared
network connection as a pass-through if connecting the phone to a computer or another network
device.

DIRECT NETWORK CONNECTION

Located on the back of the phone are two fully switched 10/100 Mbps Ethernet cable ports.
The port marked with
to your phone (if required). See
information.
Network Jack
(if inline power provided,
do not install the power adapter)
Other Network Devices
or below 40° C (104° F).
is used to connect the phone to the network, as well as provide power
"Connecting to the Network and to Power"
To Other
Network Device
Ethernet Cables
j
Installation and Setup
j
To Network
Power Adapter
on page 7 for more
Power Adapter
Connection
6