Table of Contents
Advertisement
SECTION 3
OPERATING THE PRINTER
Locate the "Circulate Ink" button. Click on this button.
5.
While the ink is circulating, tap lightly on the ink tubes, located at the operator side of the printer,
and on the printhead cartridge. This will help dislodge air bubbles; allowing them to pass through
the printhead and out the non-operator side of the printhead.
NOTE: It is normal to see air bubble accumulation in the ink tubes located at the non-operator
side of the printer. This is OK.
IMPORTANT! To avoid abnormal pressure buildup in the ink system; do NOT press the
"Circulate Ink" button more than once every 15 minutes (not to exceed more than three times in
one hour).
Click on the "Diagnostics" selection (located at left side of screen).
6.
The "Diagnostics" screen will open.
Click on "Print Ink Channels" button.
7.
A page representing each individual ink channel (CMYKK) will be printed.
Once the "Print Ink Channels" page has finished printing; send it again.
8.
Repeat this process until you are satisfied with the output. You should notice that each time you
print another page, the image quality and color will improve. It may take up to ten pages before
the output is satisfactory.
NOTE: Make sure you allow the printer to completely print each page before you press the "Print
Ink Channels" button again.
9.
Now you are ready to print your job.
52
Advertisement
Table of Contents
