Formax ColorMax 7 Quick Start Manual

Step 1
Unpack your ColorMax 7:
Remove the printer and accessories
from the packaging. Store the packing
material in a safe place.
Set the printer onto a level, stable
surface. Use a carpenter's level to make
any adjustments to the work surface
where the ColorMax 7 will be operating.
A level surface is very important to the
proper operation of the ColorMax 7, and
the electronics of the unit will check for
it once powered up. Do not move the
unit while the power is on.
Step 2
Install Media Guides:
Locate the side guides and rear media
support guide in the accessory box
(wrapped in foam).
Install the side guides to the hopper
brackets where the mounting screws
are taped in place. The rear media sup-
port guide mounts with the large rub-
ber thumbscrew on the back plate, and
the media support wedge attaches to it
with a thumbscrew.
When complete, your machine should
look like this:
Q S
uick tart
Step 3

Connect Power:

Make sure that the main power switch
(item 1 in the image below) is in the OFF
position.
Plug the AC power cord into the recep-
tacle on the printer, located below the
main power switch.
Plug the other end of the AC power
cord into a 115V AC, 60 Hz (or 230V 50
Hz for international) grounded outlet
with a high-quality surge protector.
G
uide
DO NOT
turn on
the power
switch (1)
at this time!
Please turn to side 2