Table of Contents
Advertisement
SECTION 3
OPERATING THE PRINTER
3.
Loosen the locking screws, located behind
the sheet separators, and raise the
separators. Then tighten the locking screws
to hold the separators in the up position.
4.
Place a single piece of the media, to be run,
under the separators. Always place the
media against the Media Registration Side
Guide.
5.
Loosen the separator locking screw and
allow the separator to settle onto the media.
Then tighten the locking screw. Repeat for
each sheet separator.
IMPORTANT
Be sure that unused separators are
locked in their raised position. If not,
they will rub on the feed rollers, causing
transport problems and damage to the
rollers and separators.
6.
Loosen the locking knob and reposition the Adjustable
Media Side Guide so that it is about 1/32-inch from the
side of the media. Then tighten the locking knob to
secure the side guide.
Tip: If you have trouble moving the Adjustable Media
Side Guide closer to the non-operators side of the
printer, check to be sure the Rear Media Support Guide
is not getting in your way.
36
Advertisement
Table of Contents
