Table of Contents
Advertisement
5.
[A] Carefully remove
the Printhead Cartridge
from the foil packaging.
Tear at notch or cut end
with scissors.
[B] Remove the
protective plastic cover.
Hold the Printhead by the
handle and unclip the
cover from the Printhead.
[C] Remove protective
strip from the Printhead
Electrical Contacts.
DO NOT allow removed
strip to touch the
electrical contacts.
[D] Remove protective
strip from the Printhead
Nozzles. Hold the
Printhead by the handle. Pull the strip tab and slowly peel the
strip from the Printhead.
DO NOT pull the strip at less than a 45° angle from the Printhead surface.
DO NOT allow removed strip to touch the Printhead Nozzles.
TO AVOID ELECTRICAL SHOCK OR SHORTING
Before installing Printhead, make sure the contacts are DRY!
6.
Carefully insert the Cartridge into the compartment at an angle [4], with the Printhead surface
facing down and the Ink Couplings facing the Ink Revolver Couplings (ink hoses).
Once it is seated, gently tilt the Cartridge forward until it snaps into an upright position [5].
DO NOT FORCE the Cartridge into position.
DO NOT close the Printhead Latch at this time.
WARNING
SECTION 2
INSTALLING THE PRINTER
25
Advertisement
Table of Contents
