Table of Contents
Advertisement
SECTION 6
TROUBLESHOOTING
Fuzzy/Distorted Print
Fuzzy/distorted print can occur for a number of reasons; listed/shown below.
Problem: Poor original image quality (less than 300 dpi).
Solution: Use high quality images.
Problem: Choosing to print image in low resolution from software application.
Solution: Set image to highest resolution possible from software application.
Problem: Paper is buckling or bowing during the time of printing.
Solution: Try removing the PPS spacers. Try printing on a thicker piece of media (i.e. 40lb paper ) If
problem does not occur on heavier material the media you are feeding may be too flimsy.
Problem: Damaged Printhead nozzle surface; scratched from improper manual cleaning, or dirty/damaged
wiper roller.
Solution: Only use distilled water and a non-abrasive, lint free cloth to manually clean the printhead.
Replace the wiper roller at the same time the printhead is replaced. Cover the printer, when not in use, to
keep dust/debris (plaster dust) from entering the printer.
Fuzz/Distorted Print Example:
Fuzzy/Distorted
Print Example
Good Print Example:
Good Print
Example
101
Advertisement
Table of Contents
