Table of Contents
Advertisement
SECTION 5
MAINTENANCE
9.
Remove the Printhead Cartridge and install protective covers on printhead.
Be careful to avoid ink spills (drips) and stains during this process.
Store Printhead Cartridge in a sealed plastic bag with a damp cloth.
CAUTION: Make sure the cartridges electrical contacts are dry before re-installing printhead.
10. Remove all five Ink Tanks. Be careful to avoid spills or stains during this process. Wrap each ink
tank in a clean, lint-free, absorbent material and place them in a sealed plastic bag as a precaution
against any spillages during transport.
11. Place paper towels into each Ink Tank slot, making sure the towels make contact with the back of
the slots. This is done to absorb any ink that may leak from "septum needles".
NOTE: Even though the system is deprimed, some ink will remain in the lower areas of the
tubing. In transit, this residual ink may drain out.
12. Inspect the Waste Ink Tray. If it is saturated with ink; the tray should be replaced before the
printer is transported.
13. If re-boxing for transport; remove all accessories (side guides, rear media support guide) from unit
before re-boxing.
14. Re-package the printer in the original packaging material, keeping the printer level at all times.
WARNING! To help avoid damage in transit; the printer should only be shipped in approved
factory packaging. See "Unpacking" section for help with re-boxing.
Follow the sequence in reverse.
15. Ensure transport labels on the exterior box clearly indicate that the box is to be kept level at all
times.
CAUTION! The printer should remain semi-level at all times during transportation and storage.
Failure to do so may cause the printer to leak ink. For environmental requirements during storage
and shipping, refer to the details found in the "Transport Inspection" section.
16. When re-installing the printer at the new location, please refer to Section 2 (Instilling the Printer)
of this guide.
94
Advertisement
Table of Contents
