Trigger; Filling Cap; Release Button; Rear Support Hook - Fakir RAPHAEL Instruction Manual

Trigger

Filling cap

Release button

Rear support hook

Front support hook

ON/OFF switch

Temperature dial

Temperature indicator

BEFORE USE
Grasp the water tank's handle with the hand and press the
trigger with one finger, then you can take out of the water
tank for filling water.
The filling cap is attached in the water tank, if less water in
the tank, you shall open the cap and fill water. After filling
water, close it.
Press the release button with one finger and grasp the
iron's handle with the hand, and then you can slide out the
iron anti-clockwise.
When you need to replace the iron onto the thermal
insulating cushion, you can firstly insert the back of the iron
into the rear support hook, then put the soleplate on the
locking pin and press the locking pin down, and then you
can rotate the iron clockwise until the iron is fixed into the
front support hook. At this time, the iron can be secured
onto the thermal insulating cushion.
You can put the iron on the front support hook for
operation, and you can also secure the iron into the front
support hook after finishing ironing.
Plug in the appliance and press down the ON/OFF switch,
a "D" sound of buzzer will be heard and the power indicator
will be illuminated, also the low steam rate regarded as
defaulted one and its indicator will flash. Press down the
ON/OFF switch for 2 seconds, together with a "D" sound of
buzzer, both the power indicator and steam indicator will
be extinguished, and the appliance will be disconnected
from the power supply.
Turn the dial to set ironing temperature to meet the
garment changed.
When the iron is heating up, the temperature indicator will
be illuminated. Once the iron has reached the selected
temperature, it will extinguish. The temperature indicator
will be cycled on and off as the iron maintains the selected
temperature during ironing.
GB
21