Technical Data; Network Cable; Operating And Storage Conditions - NetMan 204 Installation And User Manual

TECHNICAL DATA

N
ETWORK CABLE
To connect the device to the Ethernet (10Base-T) or Fast Ethernet (100Base-T) network, a UTP
(Unshielded Twisted Pair) or STP (Shielded Twisted Pair) cable with RJ45 connectors is required.
The cable must conform to the standard IEEE 802.3u 100Base-T with 2 pairs of UTP cables of
category 5 or higher. The cable between the adaptor and the hub must not be more than 100m and
not less than 2.5m.
Pins 1 and 2 must be connected to one twisted pair, pins 3 and 6 to another.
O
PERATING AND STORAGE CONDITIONS
Operating temperature range
Storage temperature range
Maximum operating relative humidity
Maximum storage relative humidity
NETWORK CABLE CONNECTIONS
Signal
TX+
TX-
RX+
RX-
- 41 -
Pin # to Pin #
1   1
2   2
3   3
6   6
0 ÷ +40
[°C]
-5 ÷ +50
[°C]
[%]
[%]
80
90