Configuration; Overview; Configuration Via Https - NetMan 204 Installation And User Manual

CONFIGURATION

O
VERVIEW
NetMan 204 can be configured via USB, via SSH or via HTTPS.
NetMan204 comes provided as factory default with DHCP enabled and with the following
services active: SSH, HTTP, SNMP, UDP and FTP.
In order to change the configuration of NetMan 204, you have to log in as admin (default
password "admin").
5
NetMan 204 needs approx. 2 minutes to become operational from when it is powered up
or after a reboot; before this time the device may not respond to commands that are sent
to it.

Configuration via HTTPS

In order to change the configuration via https, you have to insert in your web browser the hostname
or IP address of the NetMan204 and then log in as admin (default password: "admin").
The HTTP service uses TLS (transport layer security) in order to provide cryptographic
security. However, the certificate used is self-signed and therefore the web browser may
prompt a security alert; in this case you can ignore the alert and proceed with the
configuration of NetMan204.
Once login has been effected, you can browse through the menus to configure the NetMan 204.
In order to make a new configuration effective, it is necessary to confirm it (OK button for
each configuration page changed) and then reboot the NetMan 204 (as required with a
pop-up by your web browser).
- 13 -