Ip Config Menu - NetMan 204 Installation And User Manual

IP config menu

/------------------------/
/ IP config
/------------------------/
Hostname.......:ups_server
IP address/DHCP:DHCP
Netmask........:
Gateway........:
Primary DNS....:
Secondary DNS..:
Mailhost.......:
With this menu the main network parameters can be set as described in the following table.
Field
Hostname
IP address/DHCP
Netmask
Gateway
Primary DNS
Secondary DNS
Mailhost
(1)
Ensure that the SMTP server accepts connections on port 25.
If a static IP address is assigned to the device, all the fields must be configured with the
network parameters. If a dynamic IP address is assigned, just enter 'dhcp' in the "IP
Address/DHCP" field and provide a hostname; all the other options should be ignored
because these are automatically configured with DHCP
After pressing "ESC" and "Y" to confirm exit from the menu, a screen similar to the image below is
displayed. Press the "ENTER" key to return to the main menu. The configuration must however be
saved to make it effective after restart of the device (see "Save and load" menu).
eth0 Link encap:Ethernet
inet addr:10.1.11.19
inet6 addr: fe80::202:63ff:fe04:7b1/64 Scope:Link
UP BROADCAST RUNNING MULTICAST
RX packets:145877 errors:0 dropped:0 overruns:0 frame:1
TX packets:4899 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:12740380 (12.1 MiB)
NOTE: The new settings will become effective on next reboot.
/
Parameters to be inserted
Enter the NetMan 204 host name
Enter the IP address for a static IP; enter "DHCP" for a dynamic IP
Enter the netmask to be used together with the static IP address
Enter the name or the address of the network gateway
Enter the name or the address of the preferred DNS to be used
Enter the name or the address of the alternative DNS to be used
Enter the name or the address of the SMTP server to be used to send e-
(1)
mails.
HWaddr 00:02:63:04:07:b1
Bcast:10.1.255.255 Mask:255.255.0.0
MTU:1500 Metric:1
TX bytes:2115614 (2.0 MiB)
- 18 -