Email Config Menu - NetMan 204 Installation And User Manual

Email config menu

/------------------------/
/ Email config
/------------------------/
Email address 1:myself@mycompany.com
Email address 2:service@service.com
Email address 3:anotheremail@mycompany.com
Sender address.:NetMan_204
Customer.......:MyCustomer
Report interval:01-05:10
User name......:User 1
Password.......:Password
This menu may be used to configure the addresses to which to send the alarm notification and
report e-mails and other parameters of the e-mail service as described in the following table.
Field
Email address 1
Email address 2
Email address 3
Sender address
Customer
Report interval
User name
Password
(1)
do not use the "space" character in this field
After inserting the data and pressing the "ESC" key to exit from the menu, the service can be
tested by pressing the "T" key. If the test is performed, a "@" is displayed and a test email is sent
to all the configured email addresses. After this the previous menu is shown.
Report e-mails are sent to all the addresses inserted; for alarm notification e-mails see
paragraph "Email logic menu".
/
Parameters to be inserted
Enter the e-mail addresses to which to send the alarm notifications and
reports (see note).
Enter the address from which the e-mails are sent.
Enter an identifying string; this additional information is included in the e-
mail.
Enter the delay, measured in days, between the sending of one report e-
mail and the next by using exactly 2 figures, followed by a line, an finally
by the hour and minutes on which the email should be sent.
If the server requires authentication, insert the "User name".
If the server requires authentication, insert the password.
- 23 -
DD-HH:MM
(1)