Installing The Landing Gear; Installing The Transmitter Batteries (Rtf); Installing The Flight Battery - Blade 180 QX HD Instruction Manual

Installing the Landing Gear

Install the landing gear using the
four included screws.

Installing the Transmitter Batteries (RTF)

Replace the transmitter batteries when the power LED fl ashes and the
transmitter beeps.

Installing the Flight Battery

1
1. Lower the throttle and throttle trim to the lowest settings.
2. Power on the transmitter.
3. Install the battery by sliding it into the battery mounting slot below the 5-in-1 control unit. Slide the battery into the
slots with the label facing upward so that the battery key molded into the battery end-cap comes in contact with
the key on the battery slot.
4. Connect the battery cable to the 5-in-1 control unit.
5. Place the quadcopter on its skids on a fl at surface and leave the aircraft still until the LED on the 5-in-1 control unit
is solid blue (not blinking)
CAUTION: Always disconnect the Li-Po battery from the aircraft when not fl ying to avoid over-discharging the
battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,
resulting in loss of performance and potential fi re when batteries are charged.
2
5
3
4
EN