Transmitter Setup; Installing The Flight Battery - Blade BLH02000 Instruction Manual

Transmitter Setup

DX6, DX7 (Gen 2), DX8 (Gen 2), DX9, DX18, DX20
SETUP LIST
Model Type
Airplane
F-Mode Setup
Switch 1 Inhibit
Switch 2 Inhibit
Channel Assign
Channel Input Confi g
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear Switch B
6 Aux 1 Switch H
Frame Rate
11ms
DSMX

Installing the Flight Battery

1. Set the motor arm switch to OFF (position 1).
2. Lower the throttle.
3. Power on the transmitter.
4. Attach hook material to the quadcopter frame and
loop material to the battery.
5. Install the fl ight battery on the quadcopter frame.
Secure the fl ight battery with a hook and loop strap.
6. Connect the battery cable to the aircraft power lead,
noting correct polarity.
The quadcopter utilizes an XT-60 connector. If your fl ight
™
battery uses an EC3 connector you may either use an
adapter, available in the Optional Parts list, or you may
connect the EC3 connector directly to the XT-60. The
round negative terminal of the EC3 fi ts in the angled
negative terminal of the XT-60 as shown below.
7. Do not move the quadcopter until the receiver initializes.
8. The quadcopter motors will emit initialization tones, indicating the ESCs are armed.
CAUTION: Always disconnect the Li-Po battery from the quadcopter when not fl ying to avoid over-discharging
the battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,
resulting in loss of performance and potential fi re when batteries are charged.
CAUTION: Connecting the battery to the aircraft power lead with reversed polarity will cause damage to the
power distribution board, ESCs and the battery. Damage caused by incorrectly connecting the battery is not
covered under warranty.
EN
FUNCTION LIST
Servo Setup
Chan Travel Reverse
THR 150/150 Normal
AIL 148/148 Reverse
ELE 148/148 Normal
D/R & Expo
Switch (B)
Chan Pos D/R
0 100/100
AILE 1 100/100
2 100/100
0 100/100
ELEV 1 100/100
2 100/100
Chan Travel
RUD 148/148
GER 100/100
AUX1 100/100
Timer
Mode
Expo
Time
0 Start
0
Over
0
One Time
0
0
0
6
Reverse
Reverse
Normal
Normal
Count Down
4:00
Throttle Out
25%
Inhibit
Switch Functions
Flight Mode Switch = Switch B
Motor Arm Switch = Switch H