Installing The Flight Battery; Powering On The Inductrix 200 Quadcopter; Transmitter And Receiver Binding - Blade InducTrix 200 Instruction Manual

Installing the Flight Battery

1. Slide the battery into the back of the quadcopter,
as shown, until it locks.
2. To remove the battery, press the locking tabs on both
sides of the battery and pull the battery straight out the
back of the quadcopter.
CAUTION: Always remove the Li-Po battery
from the quadcopter when not fl ying to avoid
over-discharging the battery. Batteries discharged to
a voltage lower than the lowest approved voltage may
become damaged, resulting in loss of performance and
potential fi re when batteries are charged.
Powering On the Inductrix
1. Push the power button/LED once to power on the
quadcopter.
2. Push and hold the power button/LED for 1-2 seconds to
power off the quadcopter.

Transmitter and Receiver Binding

To bind or re-bind your quadcopter to your chosen transmitter, please follow the directions below.
General Binding Procedure
1. Refer the Transmitter Setup Table to correctly setup your transmitter.
2. Lower the throttle stick to the lowest position and center all trims on your transmitter.
3. Power off the transmitter and move all switches to the 0 position.
4. Install the fl ight battery.
5. Press the quadcopter power button/LED. The quadcopter LED glows red, yellow or green, indicating the battery charge
level. The LED fl ashes green and red briefl y then continuously fl ashes blue, indicating the quadcopter is in bind mode.
6. Put the transmitter into bind mode while powering on the transmitter.
7. Release the bind button/switch after 2–3 seconds. The quadcopter is bound when the LED on the quadcopter glows solid.
8. Press and hold the quadcopter power button/LED to power the quadcopter off. Power the transmitter off.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions.
If needed, contact the appropriate Horizon Product Support offi ce. For a list of compatible DSM
please visit www.bindnfl y.com.
EN
™ 200 Quadcopter
8
®
transmitters,