Table of Contents
Advertisement
2.3 Memory Switch Settings
Change the Memory switch by this operation. (Refer to "Memory Switch Setting Table").
MODE button : Changing OPTION status.
FEED button : Changing PRINTER MODE status
* Example:
When you want to switch from the default settings to the following settings.
Bluetooth /
a
1
High Speed /
6
Follow the procedure below to change the settings.
1. Press and hold MODE for at least 5 seconds.
After the ERROR LED flashes five times, you can configure the settings.
The current communication mode will appear on the display.
1 Press MODE once to change the communication mode to Bluetooth.
Bluetooth(iAP) g Bluetooth Mode
2. Press FEED once to switch the displayed setting from the communication mode to the
baud rate.
The current baud rate will appear on the display.
2 Press MODE once to switch the baud rate to 9600 bps.
115200 BPS g 9600 BPS
3. Press FEED once to switch the displayed setting from the baud rate to the parity bit type.
The current parity bit type will appear on the display.
3 Press MODE twice to set the parity bit type to even.
NO PARITY g ODD PARITY g EVEN PARITY
4. Press FEED once to switch the displayed setting from the parity bit type to the number
of stop bits.
The current number of stop bits will appear on the display.
4 Press MODE once to switch the number of stop bits from one stop bit to two stop bits.
1 STOP BIT g 2 STOP BIT
5. Press FEED once to switch the displayed setting from the number of stop bits to the
print density.
The current print density will appear on the display.
5 Press MODE once to set the print density to high density.
DENSITY MEDIUM g DENSITY HIGH
6. Press FEED once to switch the displayed setting from the print density to the print speed.
The current print speed will appear on the display.
6 Press MODE once to set the print speed to high speed.
LOW SPEED g HIGH SPEED
7. Press FEED once to switch the displayed setting from the print speed to the black mark
sensor mode.
The current black mark sensor mode will appear on the display.
7 Press MODE once to switch the black mark sensor mode to the use.
MARK NO USE g MARK USE
9600 bps /
Even Parity /
2
3
Use /
Medium 2 /
7
8
2 Stop bit /
4
5
1 Minute Sleep
9
- 8 -
Density High /
Advertisement
Table of Contents
