Setup; Buttery Pack; Inserting Into The Printer; Charging The Battery - Star SM-S220I SERIES Hardware Manual

2. Setup

2.1 Battery Pack

2.1.1 Inserting into the Printer

1. Make sure that the printer has been turned off before you insert or remove the battery
pack.
2. Insert the battery pack into the back of the printer as in the figure shown below, follow-
ing the direction of the arrow.
3. To remove the battery back, pull back the hook, and use the opposite procedure from
the one you used to insert the battery pack.

2.1.2 Charging the Battery

Insert the battery pack into the printer to charge it.
Insert the battery charger cable into the printer's power inlet for charging.
Lamp(Red)
Charging
Lamp(Green)
Fully charged
OFF ON
- 4 -
Hook