Star SM-S220I SERIES Hardware Manual page 16

Memory Switch Setting Table
Printer Mode
1 Communication Port *1 ）
2 Baud Rate
3 Parity Bit
4 Stop Bit
5 Print Density
6 Print Speed
Black Mark Sensor *2 ）
7
8 Black Mark Sensor Sensitivity
9 Power Down
*1)Communication mode
It is possible to change the communication mode setting between Bluetooth and serial. Please
see below for details to select the proper communication mode for your application.
Bluetooth (iOS):
The display shows [Bluetooth(iAP)]. At the Bluetooth (iOS) mode, the printer can communi-
cate with an iOS device over Bluetooth.
Bluetooth:
The display shows [Bluetooth Mode]. At the Bluetooth mode, the printer can communicate
with an Android device or a device other than iOS devices over Bluetooth.
RS-232C:
The display shows [UART Mode]. At the RS-232C mode, the printer can communicate with
a device using the serial communication cable supplied with the printer. When you con-
nect the serial cable, the printer is automatically switched to serial communication from
Bluetooth communication.
*2)When the black mark sensor is set to Use, the printer cannot detect the paper–end status.
Setting
Bluetooth(iOS) *
Bluetooth
RS-232C
9600 bps
38400 bps
115200 bps *
No Parity *
Odd Parity
Even Parity
1 Stop bit *
2 Stop bit
Density Low
Density Medium *
Density High
Low (50mm/s) *
High (80mm/s)
No use *
Use
Low *
Medium 1
Medium 2
High
No use *
1 Minute Sleep
2 Minute Sleep
3 Minute Sleep
4 Minute Sleep
5 Minute Sleep
- 10 -
Display
Bluetooth(iAP)
Bluetooth Mode
UART Mode
9600 BPS
38400 BPS
115200 BPS
NO PARITY
ODD PARITY
EVEN PARITY
1 STOP BIT
2 STOP BIT
DENSITY LOW
DENSITY MEDIUM
DENSITY HIGH
LOW SPEED
HIGH SPEED
MARK NO USE
MARK USE
SENSOR LOW
SENSOR MEDIUM1
SENSOR MEDIUM2
SENSOR HIGH
PWDN NO USE
PWDN 1 min.
PWDN 2 min.
PWDN 3 min.
PWDN 4 min.
PWDN 5 min.