Ack Character; Nak Character - Datalogic Magellan 1100i Product Reference Manual

Interface Related Features
RS-232 Interface Features — cont. — cont.

ACK Character

START / END
Sets the ACK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries
of less than three digits with zeros, as in "005". To configure this feature, scan the "START/END" barcode
above to place the unit in Programming Mode, then the "Set ACK Character," followed by the digits from the
Alphanumeric table in
mode by again scanning the "START/END" barcode above.

NAK Character

START / END
Sets the NAK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries
of less than three digits with zeros, as in "005". To configure this feature, scan the "START/END" barcode
above to place the unit in Programming Mode, then the "Set NAK Character," followed by the digits from the
Alphanumeric table in
mode by again scanning the "START/END" barcode above.
46
PROGRAMMING BARCODES
Appendix C, Alpha-Numeric Pad
DEFAULT SETTING FOR THIS FEATURE: 006
PROGRAMMING BARCODES
Appendix C, Alpha-Numeric Pad
DEFAULT SETTING FOR THIS FEATURE: 021
representing your desired character. Exit programming
Set ACK Character
representing your desired character. Exit programming
Set NAK Character
Magellan TM 1100i