Preset Color; Custom Static Color; Dimmer; Master/Slave Mode - ProLights LUMIPAR7QPRO User Manual

3.5 PRESET COLOR

This fixture has preprogrammed, static looks that may be triggered without a controller. Access these
chases via the control panel on the back of the fixture.
• Remove any DMX controller from the fixture.
• Press the button MENU so many times until shows [Show Md], and press the button ENTER to confirm.
• Press the button UP/DOWN to select [Fix c] then press ENTER to confirm.
• Select the desired preset color [R - G - B - W - GB - RB - RG - RGB - RW - GW - BW - RGW - RBW - GBW - RGBW] through
the buttons UP/DOWN.
• Press ENTER button to confirm.

3.6 CUSTOM STATIC COLOR

This fixture has the ability to accept custom static color settings. Access this via the control panel.
• Press MENU button until [Show Md] appears on the LCD screen.
• Press ENTER button.
• Using UP/DOWN button, select [Maun c] and press the button ENTER to confirm.
• Select with the buttons UP/DOWN the desired color (R, G, B, W) and press ENTER.
• Using UP/DOWN button, select the desired color value [000 - 255]. By selecting 000, the color will remain off.
• Press ENTER button to continue to the next color (R, G, B, W).
• Using UP/DOWN button, select the desired color value [001 - 100].
• Continue until the desired mix is obtained. The order of colors is red, green, blue and white.
• Press ENTER button to continue to the strobe setting.
• Using UP/DOWN button, select the desired strobe value [000 - 255]. By selecting 000, the strobe function
will remain off.
• Press ENTER button to save the final color setting. This will move the selection to the following color.
However, this is necessary to save the modification.

3.7 DIMMER

Enter to [DIME Md] to select specific dimming curve. Mode1/2/3 are speed modes of the not linear dimmer;
[DIM1] is the faster, while [DIM3] is the slowest.

3.8 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows [M&S Md], and press the button ENTER to
confirm.
• Press UP/DOWN to set the unit as [Slaver]
• Select on Master unit the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).

3.9 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
LUMIPAR 7QPRO
9