Legato Networker - Cobalt Digital Inc RaQ XTR User Manual

Legato NetWorker

To configure the Legato NetWorker backup and restore solution:
1. Select Server Management > Backup and Restore > Legato NetWorker.
The "Legato NetWorker Backup Settings" table appears. See Figure 80.
2. Enter the following information:
• Enable Client—Click to enable the check box to enable the Legato
NetWorker backup client.
• Legato Server Hostnames—Enter the fully qualified domain names of
Legato NetWorker backup servers. Legato servers must have valid host
names.
• Service port range—Sets the range of the system's service ports to the
one specified (7937—9936).
• Connection Port Range—Sets the range of the system's connection
ports to the one specified (10001—30000).
3. Click Save. The table refreshes and displays the new configuration.
To configure the Legato NetWorker backup server, see Appendix F, "Disaster
Recovery with Third-Party Software".
Figure 80 shows the "Legato NetWorker Backup Settings" table.
Figure 80. Legato NetWorker Backup Settings table
Cobalt RaQ XTR User Manual
Backup and Restore
163