Declaration Of Conformity - DeVilbiss GTI Operation Manual

E
E
Read and follow all instructions and Safety Precautions before using this
This product is suitable for use with both waterbased and solvent based
coating materials. The design uses EPA compliant atomising technology to
reduce overspray and improve coating efficiency.
Important: These guns are not designed for use with highly corrosive and/
or abrasive materials and if used with such materials it must be expected
that the need for cleaning and/or replacement of parts will be increased. If
there is any doubt regarding the suitability of a specific material contact
your local Distributor or ITW Finishing direct.
Example:
Aircap
Gunbody Finish
B= Blue Anodised

Declaration of Conformity

We, ITW Finishing Systems and Products, Ringwood Road Bournemouth
Dorset England declare under our sole responsibility that this product is in
conformity with BS EN 292: parts 1 and 2 :1991 and BS EN 1953:1999,
following the provisions of the Machinery Directive 89/392/EEC. This product
also complies with the requirements of the EPA guidelines, PG6/34. Transfer
efficiency certificates are available on request.
ITW Finishing Systems and Products reserve the right to modify equipment
specification without prior notice.
© 2007 ITW Finishing Systems and Products
Operation Manual
GTi – Suction Feed Spraygun
Important
equipment
Description
Model Part Number
GTI-S110B-14
Fluid nozzle size
(14 = 1,4 mm)
B. Holt, General Manager
2