Removing The Thermal Cutout - Kyocera FS-1030D Service Manual

2G6

(5) Removing the thermal cutout

CAUTION
Do not bend the terminals of the thermal cutout.
1. Remove and split the fuser unit (See page 1-6-19).
2. Remove the heater lamp (See page 1-6-22).
3. Remove the heat roller (See page 1-6-23).
4. Remove the two screws.
5. Remove the thermal cutout.
1-6-26
Thermal cutout
Figure 1-6-27 Removing the thermal cutout
Screws