Removing The Heater Lamp - Kyocera FS-1030D Service Manual

2G6

(2) Removing the heater lamp

WARNING
The heater lamp is extremely hot immediately after the printer was running.
Allow substantial period of time until it cools down. Also, the heater lamp is fragile: Handle it with great care.
CAUTION
The heater lamps are fragile. Use extreme care when handling not to drop or break.
Do not directly touch on the heater lamp. Finger prints on the heater lamp's outer surface can prevent proper fusing of
toner on paper. When holding
When refitting the heater lamp, direct the voltage and wattage marking facing the machine's right (Heat gear Z33) side.
1. Remove and split the fuser unit (See page 1-6-19).
2. Remove all (four) separation claws (See previous page).
3. Remove two screws.
4. Remove the heater lamp from the heat roller.
1-6-22
Screw
Machine
left side
Heater lamp
Figure 1-6-23 Removing the heater lamp
Heater roller
Heater lamp
Voltage
and wattage
marking
Screw
Heat gear Z33
Machine
right side