Install The Support Plate On The Inside Of The Door; Install The Alarm Assembly; Remove The Battery Cover From The Alarm Assembly - Schlage CONNECT Installation Instructions Manual

7b Install the Support Plate on the inside of the door.
L Make sure the Touchscreen and Support Plate are straight on the door before tightening
the screws. Tighten screws fully to prevent the lock from moving over time.
Make sure the
indented circle is
facing the door.
8

Install the Alarm Assembly.

8a Remove the battery cover from the Alarm Assembly.
ELECTROSTATIC DISCHARGE
WARNING!
Touching the circuit board
may damage the lock!
Have someone hold
the Touchscreen on the
outside of the door while
you tighten the screws.
Route the cable
through the slot.
Actual Size (2)
DO NOT remove
the battery tray
(not shown)!
9