Table of Contents
Advertisement
a)
Dome device will auto line-scan between two specified points.
b)
User can set the start point by "52+SHOT+ON" and end point by "53+SHOT+ON".
c)
Line scanning speed set: user keep a manual line scan speed three seconds above, then
through"51+SHOT+ACK" to save the speed as line scan speed, use"52+SHOT+ACK" to
enable the line scan.
d)
Dwell time of line-scanning between "starting point" and "ending point" is 2 seconds.
4. Intelligent manually pan continuous scan:
When user use joystick for pan scan monitoring, keep manually 3 seconds, then press
"101+SHOT+ACK", the dome can go on with the scan speed and monitor position automatically .
Operation Manual of Intelligent Dome Camera
30
Advertisement
Table of Contents
