Table of Contents
Advertisement
2.4 Camera Installation
(Please refer to the section on Camera Installation for more details on this
operation)
Note: 1. Make sure the proper connection of flat flex ribbon that connects the camera module to the
dome device.
2. Different camera models may have different secured positions of the hole.
2.5 Startup the power supply of the dome device
Self-detecting of the dome device (rotating) and the camera (displaying dome info) starts with power
supply start up. Note: The dome device will commence with a tilt action for around 2-5 seconds
when starting self-detecting, then be blocked and make a "clicking" sound that is normal as the
dome is performing vertical positioning.
2.6 Controller Setting
Set the protocol, baud rate, and address of the keyboard controller to match the settings on the
dome. (For instructions of how to set the keyboard communication settings please refer to keyboard
controller manual).Attention: If the protocol setting of the dome is set to auto detection, the protocol
of keyboard controller can be set arbitrarily. But its baud rate should be set identically with that of the
dome device.
2.7 Start testing
When all of the above settings are completed you can start testing dome functionality.
1. Direction control test of dome device
Left
The directions (up, down, left and
right) of the dome device can be
controlled by using the keyboard
controller, as indicated in the figure.
Note: the working of dome device
is normal
Operation Manual of Intelligent Dome Camera
Up
Joystick
Down
2. Zooming control test of camera
Right
Zooming of the camera can be controlled
by zooming function Joystick or by using
TELE (zoom in) and WIDE (zoom out) on
the keyboard button.
Note: The camera and dome device are
normal
9
Zoon in
Zoom in
Zoom out
Advertisement
Table of Contents
