Table of Contents
Advertisement
Function: User can program three traces simulating manual operation.
PATTERN
1 NUMBER
2 PROGRAM A PATTERN
3 RUN A PATTERN
4 DELETE A PATTERN
5 NAME
6 NAME DISPLAY
I R I S O P E N t o b e g i n
I R I S C L O S E w h e n d o n e
9. Joystick Up/Down to move the cursor to select Name Display.
Running Pattern Tracking Operation Steps:
1.Select pending running Pattern trace from NUMBER.
2.Joy stick Up/Down to select Run a Pattern.
3.Joy stick Left/Right or press OPEN to run the trace of selected Pattern.
Delete Pattern Operation Steps:
1.Select pending Delete Pattern trace from NUMBER.
2.Joy stick Up/Down to select Delete a Pattern.
3. Joy stick Left/Right or press OPEN to enter and Click OPEN to delete the trace of selected
Pattern as below Fig 3
ARE YOU SURE TO DO THIS
IRIS OPEN TO CONFIRM
IRIS CLOSE TO CANCEL
Fig 3
Operation Manual of Intelligent Dome Camera
1
______
OFF
F i g 1
F i g 2
F ig 4
～
Press
OPEN
3.Joy stick Up/Down to select pending
operating or programming Pattern(number
range:1
3 ).
～
4.Joystick Up/Down to move the cursor to
select Program a Pattern.
5.Press OPEN to enter recording of the
manual running trace.as left Fig 1.
6.Press CLOSE to finalize the selection.
as left Fig 2.
7.Joy stick Up/Down to move the cursor to
select NAME.
8. Edit name (Please refer to name setting
section of preset position)
PLEASE WAIT...
Fig 4
22
Advertisement
Table of Contents
