Table of Contents
Advertisement
Add-ons
¤
In the Fax printer area on the right, you will see the option Parse number from fax. If
this is enabled, the destination number of the fax is taken from the document itself. For
this to work, the fax number must be saved in the document with two @ symbols at
both ends of the number. Example: @@333@@
If the Commit required option is enabled, additional confirmation is required before a
document can be sent despite the fax number being successfully identified.
¤
If the client should be launched every time the system starts, activate the Autostart
GIGASET Client at Windows logon option below.
¤
Click OK to save.
Gigaset Windows Client now creates the connection to the server. If a
connection is established, then the Gigaset PRO icon is shown in orange.
Using Gigaset Windows Client
Quick dial
¤
Right-click on the Gigaset PRO icon
in the task bar.
¤
Select the Quick dial option, enter
the number you wish to call and
confirm your input by pressing the
enter key. The call is connected.
¤
To end a call, click on Disconnect in the call manager.
Command line
To establish a connection via the Windows command line, call up the following command
in the Client directory (default setting C:\Programs\GIGASET Client):
GIGASET Client.exe PlaceCall <phoneNumber> [<phoneId> [<callId>]]
Whereby <phoneNumber> should be replaced by the required target number. As an
option you can give the ID for a specific telephone using the parameter <phoneId> in
order to make the call on this number. If you do not enter a phone ID, the call will be made
via your primary telephone. You could therefore call up the command as follows:
GIGASET Client.exe PlaceCall 1234 SIP/1003.DE410IP
If the number that is to be called contains spaces it must be placed in quotation marks:
GIGASET Client.exe PlaceCall "+49 123 45678"
54
Destination number:
About...
Configure...
Quick dial
Exit
Advertisement
Table of Contents
