Adjustment - Panasonic FP-7818 Service Manual & Parts Manual

6.5 Adjustment

Location
1
A
Not visible
1
Clearly
2
visible
3
Shipping material/Procedure
Exposure standard adjustment
(1) Enter the F6 mode.
(2) Confirm F6-11, 12, 17, 18 and 19
to "0", and change as necessary.
(3) Enter the F2 mode and set the
exposure to the center position in
the Document mode.
(4) Make a copy of Test Chart 53/54
with gray scale (P/N FQ-SJ101).
a) Gray scale "1" should not be
visible.
b) Gray scale "2" should be clearly
visible.
Note: Skip to step 11 if the density
is in target.
(5) Enter the F6-28 mode.
(6) Enter the new content.
Note: The "Reset" key is used to
enter the "–" content.
(+): Lighter side
(–): Darker side
(7) Press the "OK" key, then press the
"Print" key.
(8) Press the "Clear/Stop" key twice.
(9) Enter the F2 mode.
(10)Make a copy to confirm the
adjustment
Note: Repeat step 3 to 10 until the
proper density is attained.
(11)Press the "User Preset" and
"Clear/Stop" keys simultaneously
to escape from the F mode.
Note: Dependent on customer
requirement. Perform the
above adjustment upon
customer request.
Check
6-7