Panasonic FP-7818 Service Manual & Parts Manual page 317

(1) Dip switch function list
Functions of the dip switch (SW1) on the sorter controller PCB are shown in the
table below.
Setting
FA-S620 FA-S660
ON ON
1 2 3 4 5 6 1 2
ON ON
1 2 3 4 5 6 1 2
ON ON
1 2 3 4 5 6 1 2
ON ON
1 2 3 4 5 6 1 2
(When A4 copy paper is used) (When A4 copy paper is used)
ON ON
1 2 3 4 5 6 1 2
(When LTR copy paper is used) (When LTR copy paper is used)
ON ON
1 2 3 4 5 6 1 2
ON ON
1 2 3 4 5 6 1 2
*1: After adjustment, make sure to turn OFF all the swithces.
*1 By turning OFF all the switches, normal
copy condition is set up.
3 4 5 6
*1
• By pressing the manual staple key, the
feed motor (M2) rotates in the forward
3 4 5 6
direction (paper feed direction). To stop,
press the staple start/stop key again.
*1
• By pressing the manual staple key ( ),
the in-bin paper dtecting sensor (S1, S2)
3 4 5 6
adjustment mode is executed.
When replacing sorter controller PCB
and in-bin paper detecting sensor
(S1,S2).
*1
• To adjust the swing range of tamper bar.
When replacing sorter controller PCB,
3 4 5 6
tamper bar home position sensor and
*1
the bin unit.
3 4 5 6
By pressing the manual staple key, the
*1
guide bar operates.
3 4 5 6
Each press causes the operation of A4-R
B5 LT-R A4-R to be repeated. By
pressing the manual staple key again, the
guide bar returns to the home position and
stops.
*1
To adjust the staple position
When disassembling sorter controller
3 4 5 6
PCB, stapler home position sensor, and
the stapler unit.
Function
Page
No.
3-11