(5) F6 mode Adjustment and programming
Set the copier to service mode and press Muiti-Copy key "6".
Press Print key.
Select desired code number with touch panel display and touch the OK key.
If you wish to select other code number, scroll the menu with arrow keys (
The display will indicate memorized number.
Input the new setting number with Multi-Copy key or Up/Down key.
Increase: Multi-Copy key or Up key of touch panel display
Decease: Reset and Multi-Copy key or Down key of touch panel display
The OK key is touched on the touch panel display, the memory number changed
is now in memory.
When the CANCEL key is touched, the desired code input will not be accepted.
Press Clear/Stop and User Preset key to escape service mode.
Code
Item
00
100% selection
(Ratio of vertical and
parallel position to the
paper feed direction)
(standard = 100%)
01
Just 100% (Ratio of
parallel position to the
paper feed direction)
02
100% focus
03
Just 100%
(Ratio of vertical position
to the paper feed direction)
04
Original registration
detecting timing (Reduction
and Enlargement copying)
Function
Adjustment from 99.1%
0.10%
to 100.9%
(–9 to +9)
(+): Enlargement
(–): Reduction
Adjustment of ratio for
0.10%
parallel position.
(–9 to +9)
(L/T)
Adjustment of focus.
(–50 to +50)
Adjustment of lens stop
(–50 to +50)
position by lens home
(+): Enlargement
position. (S/S)
(–): Reduction
Adjustment of original
0.2mm
registration detection
(–30 to +30)
timing .
(+): Delayed
(–): Advanced
).
Remarks
*If you adjust the
content of F8-02
mode, the content
of F6-04mode is
automatically
changed from the
factory setting.
5-23