Adjusting The Volume; Initial Programming Of The Unit - Panasonic DP-MB251CX Operating Instructions Manual

3. Preparation

3.4 Adjusting the volume

Important:
R Before adjusting the volume, set the operation
mode to fax mode. If the MFAXN light is OFF, turn
it ON by pressing MFAXN.
Ringer volume
While the unit is idle, press MCN or MDN.
To turn the ringer OFF
Press MCN repeatedly to display "RINGER OFF= OK?".
A MSETN
R The unit will not ring.
R To turn the ringer back ON, press MDN.
Handset receiver volume (DP-MB251CX only)
While using the handset, press MCN or MDN.
Monitor volume
While using the monitor, press MCN or MDN.
22

3.5 Initial programming of the unit

3.5.1 Date and time
We recommend setting the date and time. The other
party will receive your unit's date and time as the header
information.
1
MMENUN A MBNM1NM0NM1N A MSETN
2
Enter the current date/month/year by selecting 2
digits for each.
Example: 3 August, 2015
M0NM3N M0NM8N M1NM5N
3
Enter the current hour/minute by selecting 2 digits for
each.
Example: 10:15 PM (12 hour clock format)
1. M1NM0N M1NM5N
2. Press MGN repeatedly to select "PM".
Press MGN repeatedly to select "AM" or "PM", or
24-hour time entry.
4
MSETN A MMENUN
Note:
R To check the current date and time setting,
temporarily change the unit to the fax mode by
pressing MFAXN (page 21).
R Your unit's date and time will be used as the header
information for the following:
– When sending as an attached file to an email
destination directly from this unit (Scan to email
address) (page 42).
– When sending faxes (page 57).
R If the date and time is not set correctly, the other party
will receive an incorrect date and time as their
header. This may confuse the other party.
To correct a mistake
Press MFN or MEN to move the cursor to the incorrect
number, and make the correction.
If you have subscribed to a Caller ID service
The date and time will be automatically set according to
the received caller information.
R To use this feature, make sure the time adjustment
is set to "AUTO" (feature #226 on page 74).
R If the time has not previously been set, Caller ID will
not adjust the clock.
3.5.2 Your logo
You can program your logo (name, company name, etc.)
so that it appears on the top of each page sent.
1
MMENUN A MBNM1NM0NM2N A MSETN
2
Enter your logo, up to 30 characters (see page 53
for character entry).
3
MSETN A MMENUN