JRC JHS-770S Instruction Manual page 68

Operation
5 .
5 .
5 .
Press ENT.
Confirm the entered contents.
6 .
6 .
6 .
If the contents are correct, press ENT.
The sending confirmation screen will appear.
The controller displays by default only
Note
the edited information in the call setup
as shown at right.
7 .
7 .
7 .
Press ENT to transmit the call.
After completed the transmission, the popup
screen shown at right will be displayed to wait
the acknowledgement.
If received no response for 5 minutes,
Note
the screen will return to the step 5
mentioned above.
8 .
8 .
8 .
When received the acknowledgement, the
screen shows the message with the alarm
for 3 sec. Then changes to the proposed
working channel automatically.
If 9.5.2 Automatic CH shift is OFF,
-
Note
lifting the handset or pressing ENT
is required to set the proposed
working channel.
-
If an improper channel is proposed,
resend the call containing a new
channel via the specified new
channel proposal form screen.
9 .
9 .
9 .
The ship station call will be completed
after displayed the working channel as
shown at right.
Start communications using the handset.
The example at right shows when proposed
CH06 as a working channel.
When completed the communications,
return the handset to the cradle.
If the ship station is unable to comply with the call, as with coast stations, own station
Note
(caller) may receive a negative acknowledgement mentioned above section.
case, if possible according to the message, wait and retry the calling again later.
4-24
1.2)Ship station call
Address :[112233445]
Work CH :[06]
[ OK ] [Cancel]
1.2)Ship station call
Address :112233445
Work CH :06
[Call] [Cancel]
1.2)Ship station call
Address :123456789
Work CH :71
Waiting for
Acknowledgement.
[Cancel]
[Call] [Cancel]
Station1 TIME 23:59(UTC)
POS
EXT 179ﾟ59'W
06
CH
[ITU]
SQL
CH70
CH
SW
89ﾟ59'S
In this