Own Ship Position And Time Setting - JRC JHS-770S Instruction Manual

5.2

Own ship position and time setting

Normally, the ship's position and the time will be updated automatically if importing GPS information.
But if necessary, input these parameters manually as follows.
The time described below means the time when the position information is valid, and is different
from the present time mentioned above.
■ ■
Procedure
1 .
1 .
1 .
Press the
MENU
menus, select the 9.2 POS/TIME.
2 .
2 .
2 .
To input own ship's position, press ENT.
Select the position quadrant with the jog dial, and press ENT.
Then input the latitude and longitude, and press ENT with
the numeric keypad or jog dial.
3 .
3 .
3 .
After completed the above steps, the cursor will
move to the 2. UTC of position.
4 .
4 .
4 .
To input the UTC of position, press ENT.
Input the hours and minutes, and press ENT.
To finish this menu, place the cursor on the any one
of the selective items and press the
key.
Note
- If received the position and the time information from the external device, such as a GPS,
the manually entered data will be overwriten automatically.
- If not received the position and the time information within 5 minutes after powering on, or
after 5 minutes elapsed since interrupted, this menu will appear with the alarm automatically.
Further, regardless of either manually or automatically if not updated the position and the
time within 4 hours after the last entry, this menu will appear repeatedly.
CAUTION
key, and through hierarchical
CANCEL
Settings & Registrations
9.2)POS/TIME
1.Own position: NE
89ﾟ59'N
179ﾟ59'E
2.UTC of position:
23:59
9.2)POS/TIME
1.Own position: NE
89ﾟ59'N
179ﾟ59'E
2.UTC of position:
23:59
9.2)POS/TIME
1.Own position: NE
89ﾟ59'N
179ﾟ59'E
2.UTC of position:
23:59
9.2)POS/TIME
1.Own position: NE
89ﾟ59'N
179ﾟ59'E
2.UTC of position:
23:59
5-3