Squelch Settings Of Each Channel (Preset Squelch) - JRC JHS-770S Instruction Manual

4.2.10

Squelch settings of each channel (preset squelch)

The adjusted squelch value can be stored with respect to each channel as a preset squelch.
handling of the preset squelch will be as follows.
・ If stored the squelch value, the preset squelch will be always set just after the channel selection.
・ While the preset squelch has been set, "p SQL" will be indicated on the status display.
・ If turned the SQL control after setting the preset channel, the preset value will be canceled
immediately and the SQL control will be available.
・ The preset squelch value can be cleared with respect to each channel or each channel region.
■ ■
Procedure
1 .
1 .
1 .
After selecting the desired channel, press
the key and through hierarchical
MENU
menus, select the 7.7 CH SQL setting.
2 .
2 .
2 .
Turn the SQL control to the appropriate
position.
The SQL value as shown at right will be
changed corresponding to the SQL control
position.
3 .
3 .
3 .
Press ENT.
The cursor will move to the right.
4 .
4 .
4 .
To complete the squelch setting for the
channel, select "Set" and press ENT.
- To clear the preset squelch values with respect to each channel, after selecting the
Note
channel, select Erase and press ENT at the step 3 above.
- To clear the preset squelch values with respect to each channel region, in the
condition of that channel region, move the cursor to the 2. All clear and press ENT.
-
The above operation is also available on a popup menu displayed when pressed both
of the FUNC key and the CANCEL
7.7)CH SQL setting
SQL value [052]
1.Preset : Set
2.All clear
0.Back
7.7)CH SQL setting
SQL value [041]
1.Preset : Set
2.All clear
0.Back
7.7)CH SQL setting
SQL value [025]
1.Preset :
2.All clear
0.Back
7.7)CH SQL setting
SQL value [025]
1.Preset : Set
2.All clear
0.Back
key simultaneously on the status display.
Operation
The
Set
4-13