How To Power The Tester; Replacing The Battery (Tester) - MOTO GUZZI V11 SPORT MY 2003 Workshop Manual

A
B
C
3
D
E
2
F
1
G
H
I
L
M
N
O
P
Q
R
100
2
1
3 4
1. POWER connector:
To charge the internal battery, using only the charger
supplied.
2. Lower parallel-serial connection:
This connector acts as an interface between the
AXONE2000 and external units such as: printers, re-
mote terminals, serial devices, etc...
This connector is also used to power the AXONE2000.
3. Upper connector:
Depending on the interface module inserted in the
AXONE2000, the connector is used to carry out
special tests or characteristics for per form
AXONE2000 diagnostic functions, using the standard
cables provided in each kit.
H AXONE2000
OW TO POWER THE
The AXONE2000 can be powered automatically by
means of an internal battery (self-powered) or externally
using the cable provided.
The figure shows the connections to be made:
• Connect the cable of the kit in use (1) to the upper
connector (2) and connect the battery clamp cable
(4) to the connector.
The internal battery will be automatically recharged when
the AXONE2000 is powered externally.
IMPORTANT:
The battery charger must only be used for
recharging the batteries and never to power the
instrument externally.
R
EPLACING THE BATTERY
The battery is contained in a compartment in the base of
the AXONE2000. Delicately open the retainer by inserting
a pointed object (e.g. a screwdriver) in the slot indicated
by the arrow to open the flap and access the battery
compartment.
The flap will open.
Access the battery compartment to replace the battery.
Make sure the battery is correct connected as shown on
the label inside the compartment.
IMPORTANT:
The battery is charged when supplied. The
charge level may present normal decay. For this
reason, you are advised to recharge the battery
completely for 12-18 hours before normal use.
V11 S M 2003 - L
PORT Y
R C - C
OSSO ORSA AFE
M M 2003
E ANS Y
S - B
PORT ALLABIO VARIANTS