MOTO GUZZI V11 SPORT MY 2003 Workshop Manual page 181

A
B
C
D
E
F
G
H
I
L
M
N
O
P
Q
R
114
Q
P
R
Q
R
· Gradually open both by-pass screws so as to reach
an idling speed of 1,100 ± 50 RPM (read value on
AXONE2000), after having selected the rpm param-
eter, by keeping the vacuum balance;
Engine temperature shall be between 70 and
°
80 C
· Disconnect the vacuometer and check idling speed;
· Switch off and disconnect AXONE2000;
No special procedure is needed to switch off AX-
ONE2000: simply press "ON/OFF" "11" from any menu.
AXONE2000 may jam during operation.
If this is the case, turn the key to
switch off AXONE2000 by pressing "ON/OFF"
"E", disconnect upper connector and wait for a
few seconds before connecting the tester to
control unit again.
If once this procedure is over the idling speed is not
within the specified limits, use a tester to check the
throttle position sensor as follows:
· fully close the throttle duct (throttle angle 0°);
· turn the ignition key to ON
· install the tester probes inside the throttle position
sensor connector across terminals "Q" and "R" and
check that the voltage reading is 150mV +/- 15mV.
· If the throttle position sensor reading does not fall in-
side the above values, loosen fastening screw "P"
and proceed to correct re-positioning.
V11 S M 2003 - L
PORT Y
R C - C
OSSO ORSA AFE
"OFF",
;
M M 2003
E ANS Y
S - B
PORT ALLABIO VARIANTS