Casio QT-2100 Service Manual page 10

3-2. How to initialize QT-2100 terminal (add/replace one QT-2100)
1. All peripheral devices and QT-2100 terminals of this cluster should be turned off.
2. Connect all of the peripheral devices (such as printer, display etc.) to this QT-2100 terminal.
3. Connect this QT-2100 terminal to in-line.
4. Turn on all peripheral devices of this QT-2100 terminal.
And turn on all QT-2100 except this terminal of the cluster.
5. Turn on this QT-2100 terminal with pressing the left-most key of the top row and release the key after
buzzer sounds.
6. After releasing the key, enter "other = 1000, USA = 2000" and press the right part of the <ST> key.
7. Refer to "2-1 How to initialize QT-2100 terminal" on page 3.
2-3. How to flag clear QT-2100 terminal (or INIT2)
Preparation:
Operation:
10-10-01 12:34
INIT
1.Flag Clear
2.Init2
Note:
Performing "Init 2" requires password "8888888888".
1. This QT-2100 terminal should be turned off.
2. Check the connection of all peripheral devices (such as printer,
display etc.) of this QT-2100 terminal.
3. Check the connection of this QT-2100 terminal to in-line.
4. Turn on this QT-2100 terminal with pressing the right-most key
of the top row and release the key after buzzer sounds.
5. After releasing the key, press the <ST> key.
6. Select "1.Flag Clear" and press the <YES> kye.
0.00
The flag clear operation is finished.
— 8 —