Configuration (Dmx); Dmx Personalities; Dmx Control; Loss Of Signal Setting - Chauvet ColorAdo 1-Quad Zoom Tour User Manual

Hide thumbs Also See for ColorAdo 1-Quad Zoom Tour:
Table of Contents

Advertisement

Configuration
(DMX)
DMX
Personalities

DMX Control

Loss Of Signal
Setting
Zoom Limit
Settings
Colorado™ 1-Quad Zoom Tour User Manual Rev. 1
Use DMX configurations to operate the product with a DMX controller.
This setting allows you to choose a particular DMX personality.
1. Go to the PERS main level.
2. Select the desired personality (TOUR, TR16, STD.Y, FULL, C1Q, ARC.1, AR1.D, ARC.2,
AR2.D, AR2.S, AR2.Z, or HSV).
·
See the DMX Values section for the highest starting address you can select for each
personality.
·
Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX controller. All
products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the running mode:
a. Go to the RUN main level.
b. Select the DMX programming level.
3. Set the starting address:
a. Go to ADDR main level.
b. Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX
DMX
Personality
Address
TOUR
501
ARC.1
510
AR1.D
509
FULL
488
This setting controls how the product will respond when the DMX signal is lost.
1. Go to the SET main level.
2. Select DERR.
a. Select SAVE to make the product use the last command used when the signal is lost.
b. Select BLAK to turn off the all the LEDs when the signal is lost.
These settings allow you to select the zoom range. Basic zoom (BASE) is the default setting
which allows the zoom to move at full range (000–255) and has no adjustable limit. Position 1
(POS.1) and Position 2 (POS.2) allow you to set limits on how far the zoom moves.
1. Set the zoom range to be used:
a. Go to the SET main level.
b. Select ZOOM.
c. Select BASE, POS.1, or POS.2.
2. Set the limit for zoom range POS.1 or POS.2:
a. Go to the ZOOM main level.
b. Select POS.1 or POS.2.
c. Select a zoom limit value (P.000–255).
DMX
Personalities.
DMX
DMX
Personality
Address
ARC.2
509
AR2.D
508
AR2.S
507
C1Q
503
Operation
DMX
DMX
Personality
Address
HSV
510
TR16
496
STD.Y
496
AR2.Z
506
-15-

Advertisement

Table of Contents
loading

Table of Contents