Service Mode - Midea G01 Service Manual

6.TROUBLESHOOTING

6.5 Service Mode

Before entering into service mode, make sure no water remains in the inner drum, if not, select drain
only program to drain them out.
Turn on the machine and press
mode. Press or
Delay Speed
and start the selected test. If you want to go back to test selection interface, press the
button to cancel previous selection.
6.5.1 Version switchover (t01)
1) Enter into service mode, LED displays "t01"
2) Press Start/pause button, LED displays "0xx".x means
3) Press to confirm switchover.
Delay
4) Press to change version.
Speed
5) Press Delay button continuously for 3s to confirm your change.
6) Press Start/pause button to close all output and exit this program. LED displays "t01".
6.5.2 Error code checking (t02)
1) Enter into error code mode, LED displays "ELT". Press Delay button and LED displays
EXX(x=1,2,3....)
2) Press to show the last code and press Speed to show the next code. The latest 10 error codes
Delay
can be found in system, and same error code is recorded one time even if it occurs more than one time
3) If no error information found, LED shows E00.
4) Press continuously for 3s, after hearing the beep, all the error codes records deleted, LED
Delay
displays E00.
5) Press Start/pause button to exit, LED display t02.
6.5.3 Version information checking (t03)
Version information checking is used to show the current version information stored in nonvolatile
memory applications.
1) Enter into service mode, LED displays "Sut".
2) Press button, LED displays repeatedly "cod" and version number "0xx" repeatedly each for
Delay
1s.
3) Press Start/pause to go back to version information checking status, LED display "t03".
6.5.4 UI Checking (t04)
1) Press Start/pause button to illuminate the whole LED display.
2) Press button, the whole LED display flashes.
Delay
3) Press to stop flash, LED display "t04"
Start/pause
6.5.5 Drain pump checking (t05)
1) Enter into service mode, LED displays "PPt".
2) Press button to drain out all the remaining water. If all water drained out, LED displays
Delay
，
"EP" and 6 minutes later ,if there is still water remains in it, LED displays "FP".
3) Press Start/pause button to exit, LED displays "t05"
6.5.6 Pressure switch checking (t06)
）
1 Enter into service mode, drain out the water, LED displays EPT.
2) Press button to activate inlet valve. LED displays L1 once water lever get the main wash
Delay
level.
3) Press Delay to close inlet valve, LED displays "t06"
4) Press button to exit, LED displays "t06"
Start/pause
6.5.7 Water temperature sensor and heater checking (t07)
1) Enter into service mode, drain out the water, LED displays the current temperature of inner drum.
2) If water switch works,
3) Press button to activate the main inlet valve and get the water lever to heating level then turn
Delay
on the heater and 5 min later turned off automatically.
4) After heater turned on, LED displays the current temperature. Detect the real temperature of inner
drum and check with the numbers on the display.
5) Press Start/pause button to exit, LED displays "t07"
Delay and Temperature
to select test program. Press
in proper order for 30s to enter into service
button to confirm your selection
Start/pause
Start/pause
P.53