Installation; Select The Location; Remove Transport Bolts; Adjust Leg - Midea G01 Service Manual

3.INSTALLATION

3.1 Select the location

1. Washing machine must be placed in the formation, firm, dry and well-ventilated places.
2. Washing machine need a certain space and the shortest distance from the wall is not
less than 12cm generally.
3. Don't place the washing machine in the condition of freeze-easy.
4. Washing machine should be placed away from heat, sunlight to prevent pieces of
plastic and rubber become aging.
5. Do not put the washing machine in the place where it can be exposed to rain and snow.
6. It is not suitable to use the washing machine on vessels, aeroplanes and vehicles.
7. To avoid walling up the vent, please don't put washing machine on the carpet.
NOTE: Washing machine should be put in the room which have enough space, such as its
door can be fully opened.

3.2 Remove transport bolts

Before using this washing machine, transport
bolts must be removed from the backside of
this machine.
Please take the following steps to remove the bolts:
1. Loosen all bolts with spanner and then
remove bolts.
2. Stop the holes with transport holes plugs.
3. Keep the transports bolts properly for future
use.

3.3 Adjust leg

1. When positioning the washing machine,
please first check whether the leg are closely
attached to the cabinet. If not, please turn them
to the original position with hand or spanner
and tighten them with spanner.
2. After position washing machine, press four
corners on top cover of this machine in
sequence. If the machine is not stable, this
leg should be adjusted.
3. To ensure the positioning status of washing machine, loosen the lock nut with spanner
and turn the leg with hand until it closely attaches to floor. Press the leg with one hand
and fasten the nut closely to the cabinet with the other hand.
4. After being locked properly, press four corners again to make sure that they have been
adjusted properly. If it is still unstable, above-mentioned steps shall be repeated by 2
to 3.
NOTE: In principle, there is only one loosen leg at most. If this leg is located at back of
this machine and it is inconvenient for adjustment, then another leg at its diagonal position
can be adjusted to achieve the same effect.
P.17