Connect Inlet Pipe; Place Outlet Hose; Electrical Connection - Midea G01 Service Manual

3.INSTALLATION

3.4 Connect inlet pipe

Connect the inlet pipe as indicated in the figure.
1.Connect the elbow to tap and fasten itclockwise.
2.Connect the other end of inlet pipe to the inlet
valve at the backside of washing machine and
fasten the pipe tightly clockwise.
NOTE: after connection, if there is any leakage with
hose, then repeat the steps to connect inlet pipe. The
most common type of tap shall be used to supply
water. If tap is square or too big, then standard tap
shall be changed.

3.5 Place outlet hose

There are two ways to place the end of outlet hose:
1. Put it beside the water trough.
1) Washing machine shall be located nearby the
slipway's inlet so that it is convenient for this
machine to drain.
2) Take out splint from PE bag and fasten it on the
end of the drain hose, and then put it beside the
water through or the slipway's inlet.
NOTE: clean up the filter of outlet valve, don't fold it,
don't clog the inlet/outlet hose to make sure them
expedite to inlet or drain.
2. Connect it to the branch drain pipe of the though.

3.6 Electrical connection

1. The maximum current through the unit is 10A when this machine heats the washing
liquid, and please make sure that your household power supply system (current, power
voltage and wire) can meet the normal loading requirements of the electrical appliances.
2. Please connect the power to a socket which is correctly installed and properly earthed.
3. Please make sure your household power voltage is same as that of the machine's rating
label.
4. Power plug must match the socket and cabinet must be properly and effectively earthed.
5. Do not use multi-purpose plug or socket as extension cord.
6. Do not connect and pull out plug with wet hand.
7. When connect and pull out plug, hold the plug tightly and then pull it out. Do not pull
power cord forcibly.
8. If power cord is damaged or has any sign of being broken, special power cord must be
gotten from its manufacturer or service center for replacement.
9. Has been positioned, the plug of Washing machine should get to socket properly and
effectively.
100cm
140cm
110cm
P.18