Function Of Auto-Balance; Function Of Child Lock; Program Memory; Function Of Motor Self-Protection - Midea G01 Service Manual

2.INTRODUCTION OF PRODUCTS

2.7.4 Function of auto-balance

1. This function will start before spin and after drainage.
2. Drum reverses the speed of 50 rounds per minute in the first six seconds.
3. In the next 10 seconds, the rotational speed from 50r/m to 100r/m slowly.
4. In the following 18 seconds, the washing machine rotates in the speed of 100r/m and
estimates the degree of imbalance according to the signal of the motor.
5. If the degree of imbalance is more than the setting value, the auto-balance system will
feed back imbalance information of 12 cycles.

2.7.5 Function of child lock

To avoid the fault operation by children and then making this wash procedure work
abnormally, you can select this function in which other buttons can't be work except knob.
As for this machine, press the second button and the first button at the same time for 2.5
seconds from left , the buzzer rings and the pre-wash button, auxiliary function button,
start/stop and knob are locked. And then, press them at the same time for another 2.5
seconds, the buzzer rings again and the locked buttons are unlocked. Child lock function
is cancled after the whole program is completed when child lock is effective, press the
non-child lock button and then buzzer rings to remind that operation is invalid.

2.7.6 Program memory

If the running washing machine is powered off, its washing procedure will be stored in
chips. When the power is on, washing machine will run from the memorying procedure.
If washing machine is powered off during spin, the machine will spin from the start of the
procedure again.

2.7.7 Function of motor self-protection

When the washing machine works in the poor conditions, the enormous load on the motor
will make its temperature increase and its performance decrease even burned motor.
When its temperature increases to a set value, the thermal protector of motor will
automatically cut off the power supply to achieve self-protection and alarm.
P.16