Cabinet Kit; Panel Support - Midea G01 Service Manual

4.OVERVIEW OF MAIN COMPONENTS

4.6 Cabinet kit

The material of the cabinet is PCM colorful metal,
and cabinet fold and reinforce are fixed by TOX
riveting technique, the panel support is fixed with
cabinet with screws.
Fixed in the top of the cabinet through TOX riveting
technique, left and right-up reinforce reserve spring
hole, pressure switch assembly hole, cable channel
hole and screw hole of the PCB board support.
Left and right-down reinforce on top of which it is
special fold design of fixing absorber is fixed down
of the cabinet through riveting techque.
Down reinforce is riveted down of the cabinet front
cover, on top of which the lower panel fixing hole is
reserved. The bigger hole is used to fix the pump,
down of which is two screw hole used to fasten the
lower panel.
The left and right hole on the up-front of the cabinet
is panel support hole.
There are inlet valve fixing hole, cable holder-s
hole, outlet hose hole, and power cord hole from
left to right on the up-back of the cabinet.
In the convenience of maintenance, there is a
bigger rear panel hole in the middle of the cabinet.
When fixing the rear panel, you should insert the
upper part into the hole, then fix two screws in the
bottom.
The three holes around the rear panel are transmit
bolt holes.
Furthermore there are three outlet hose fixing
support holes on the upper and left of the rear
cabinet to fix the outlet hose and power cord.
And there is two-leg power plug on the left of the
bottom.

4.7 Panel support

As the metal slat, Panel support is used to increase
the intensity of cabinet and fixed on the control panel.
Panel support is fastened on the cabinet with two
screws locating its both sides.
P.22